Straight answer: the inground pool monthly maintenance cost runs about $85 to $200 if you do it yourself, and $180 to $400 a month if a service handles it. Then set aside another $600 to $1,200 a year for the parts that eventually quit. Anyone who quotes you one tidy number has left something off the list.
Pools are not expensive the way people fear. They are expensive the way a car is expensive — a modest monthly cost plus an occasional larger bill that arrives on a day you did not pick.
The monthly breakdown, line by line
| Line item | DIY | With weekly service |
|---|---|---|
| Chemicals | $35–$80/mo in season | Included |
| Electricity (pump + cleaner) | $25–$70/mo | $25–$70/mo |
| Water (evaporation + backwash) | $10–$25/mo | $10–$25/mo |
| Labor | Your Saturday | $100–$250/mo |
| Filter media / minor parts | ~$10/mo averaged | ~$10/mo averaged |
| In-season total | $85–$200 | $180–$400 |
Off-season in a mild climate, cut that roughly in half. In a market where pools genuinely close for winter, a closing runs $200 to $400 and an opening about the same.
Electricity is the line item people get wrong
Everyone budgets for chlorine. Almost nobody budgets for the pump, which is the single largest recurring cost of owning a pool.
An older single-speed 1.5 HP pump pulls somewhere around 1,500 watts. Run it eight hours a day and that is roughly 360 kWh a month — call it $40 to $70 depending on your rate. A variable-speed pump doing the same water turnover at 1,200 RPM instead of 3,450 draws a few hundred watts, because power draw falls dramatically as speed drops.
This is settled enough that the U.S. Department of Energy's dedicated-purpose pool pump rule, effective July 2021, made variable-speed the practical standard for most new residential pool pumps. If yours predates that and hums like a shop vac, it is costing you money every single day.
Here is our one strong opinion in this whole article: replace the single-speed pump before you do anything else cosmetic. A variable-speed swap typically runs $900 to $1,700 installed and commonly pays for itself in 18 to 30 months on the power bill alone. No other pool upgrade returns money like that. New tile does not save you a dime.
Chemicals: what you are actually buying
For a 15,000 to 20,000 gallon chlorine pool in a sunny climate:
- Trichlor tablets — the bulk of it, roughly $20 to $50 a month in season
- Shock — $10 to $20 a month, more after a pool party or heavy rain
- Muriatic acid — a few dollars a month, more if your fill water is hard
- Stabilizer (cyanuric acid) — occasional, but critical in Bell and Coryell counties sun; keep it at 30 to 50 ppm or the sun burns your chlorine off before lunch
- Calcium and alkalinity adjusters — situational
A saltwater pool replaces most of the chlorine spend with about $70 to $100 a year in salt, then hands you a salt cell bill every three to seven years. Our saltwater maintenance guide walks through what that routine actually looks like.
The repair fund nobody sets up
This is the part that turns a fine month into a bad one. Nothing here is unusual — it is just the normal lifespan of pool equipment.
- Pump motor or full pump: $400 to $1,700, every 8 to 12 years
- Filter cartridges: $80 to $400 per set, every 3 to 5 years
- Sand media change: $150 to $400, every 5 to 7 years
- Salt cell: $200 to $700, every 3 to 7 years
- Heater repair: $200 to $800; full replacement $2,500 to $6,000
- Resurfacing: $5,000 to $12,000, every 8 to 20 years depending on finish
Averaged out, that is $50 to $100 a month you are not writing a check for yet. Put it somewhere you will not spend it, and the day the pump dies mid-August becomes an inconvenience instead of an event.
When you should skip the pool service
We sell weekly service. We would still rather you read this honestly.
Skip it if you are home most weeks, your pool has light tree cover, and you will actually test the water twice a week. That is maybe 25 minutes of real work — brush the walls, empty the baskets, test, adjust. You save $1,200 to $2,400 a year. Buy a decent test kit rather than the paper strips and you are ahead.
Hire it out if you travel, you are in your first season with a pool you did not build, you have heavy leaf drop, or your pool has already gone green once. Green water is not a chemistry problem at that point, it is a $300 recovery and a week of nobody swimming.
There is also a middle option people forget: chemicals-only service, where a tech balances the water every week and you do the physical cleaning. Usually $60 to $120 a month, and it prevents the expensive mistakes.
The call we get every August
The pump died during a heat wave, the water went from clear to hazy to green in four days, and now the owner wants a same-week visit. It is the most predictable call of our year.
Almost always the pump had been getting louder for a month. Rising noise or a motor hot enough to be uncomfortable to touch is a bearing telling you it has maybe eight weeks left. Catching it then is a $400 motor swap on a Tuesday. Catching it in the green-water phase is the motor plus a chemical recovery plus a filter clean.
How to cut your monthly cost without cutting corners
- Run the pump longer at lower speed. Turnover matters, RPM costs money.
- Keep cyanuric acid at 30 to 50 ppm. Too little and the sun eats your chlorine; too much and the chlorine stops working and you buy more.
- Use a cover if you have anywhere to store it. It cuts evaporation and chemical loss substantially, and it is the least glamorous money-saver in the industry.
- Clean the salt cell on schedule instead of buying one early.
- Brush the walls weekly. Algae starts where water does not move. Two minutes of brushing beats a bottle of algaecide.
Killeen Pool Builders does weekly pool cleaning and weekly service across Killeen and Bell and Coryell counties, and we are happy to tell you when the DIY route is the smarter call. If your pump is the thing eating your budget, start with our pool heater and equipment cost guide or just call (844) 511-2320 and describe the noise.
Get a free quote → · call (844) 511-2320
Ready for a free quote in Killeen?
Killeen Pool Builders — free estimate, clear scope, no pressure. Use the form on this page or jump to the homepage quote.
Related services in Killeen
Killeen Pool Builders money pages — go straight to the service you need.
- Pool Remodeling & Renovation →
Pool remodeling covers the jobs that change the pool rather than just refinish it: adding a spa with a spillover, cutting in a tanning ledge, filling a deep end, raising a bond beam for a waterfall, or expanding the shell to claim back some patio. We do a lot of them in Killeen, because Fort Cavazos moves families every two or three years and a lot of these pools carry four owners' worth of repairs that nobody was here long enough to do properly.
- Pool Leak Detection & Repair →
Pool leak detection starts with one number: a Killeen pool loses about a quarter inch a day to evaporation in July, so half an inch a day means you have a leak. The water bill is the smallest part of the problem, because a return line weeping under your deck is quietly washing out the base that concrete sits on, and you'll meet that again next year in the shape of a settled slab and a cracked joint.
- Weekly Pool Cleaning & Maintenance →
Weekly pool cleaning isn't hard, it's just weekly, and it never stops. A Central Texas summer is where good intentions fall over: water at 90 degrees burns through free chlorine in about a day, our fill water arrives full of calcium, and one thunderstorm rolling off the Lampasas Cut Plain drops enough debris and phosphate to turn a clear pool green by Thursday.
- Gunite & Shotcrete Pool Construction →
Gunite pool construction gets you whatever shape you draw rather than whatever shape came out of a mold, and around Killeen the shape is the easy part. The hard part is what's under your grass, because most Bell and Coryell county lots sit on shallow Edwards limestone and caliche, and rock is the single biggest swing in a Central Texas pool price.
- Fiberglass Pool Installation →
Fiberglass pool installation trades shape for speed: the shell is built in a factory, arrives on a truck, gets craned into the hole, and a clean job goes from bare dirt to swimming in two to three weeks. On Killeen's rockier lots it's often the cheaper route as well, because a one-piece shell needs a smaller and more forgiving excavation than a gunite pool with its plumbing trenches and equipment runs, so when we hit limestone the hammer time is shorter and the bill is smaller.
Frequently asked questions
How much does it cost to maintain an inground pool per month?
Doing it yourself, most Killeen owners spend $85 to $200 a month in season once you add chemicals, electricity, and water. With a weekly pool service handling it, budget $180 to $400 a month. Both numbers exclude repairs, which average out to roughly $600 to $1,200 a year across a pool's life.
How much do pool companies charge per month?
Weekly service in most markets runs $100 to $250 a month for a standard residential pool, usually four visits, chemicals included. Add $20 to $60 a month for a large pool, a heavy tree canopy, or a spa. Chemicals-only or biweekly plans cost less.
What is the biggest hidden cost of owning a pool?
Electricity, and it is not close. An older single-speed pump running eight hours a day can add $40 to $70 a month to your bill. A variable-speed pump running longer at lower RPM often cuts that by 60 to 80 percent.
Is it cheaper to maintain a saltwater pool?
Day to day, yes. Salt runs about $70 to $100 a year versus a few hundred in tablets and shock. The offset is the salt cell, a $200 to $700 part that needs replacing every three to seven years, so over a decade the two land close.
Can I maintain my own pool and save money?
Yes, and plenty of people should. If you are home most weeks and willing to test twice a week and brush once, you save roughly $1,200 to $2,400 a year. The people who should not are travelers, first-time owners in their first season, and anyone who has already turned the water green once.
How much water does a pool lose to evaporation?
In a hot, dry Bell and Coryell counties summer a typical 16x32 pool loses about a quarter inch a day, which is roughly 80 gallons. Over a month that is around 2,400 gallons, or about $10 to $20 on most municipal water rates. Losing more than that consistently points to a leak, not the weather.
Local context
How this applies in Killeen, TX
Every article here is written from pool work done in Killeen and Bell and Coryell counties, so the numbers reflect local labour, permit and material costs rather than a national average. Your own job can land either side of them depending on access, the condition of what is already there, and the materials you pick — gunite and shotcrete shells, PebbleTec and polished quartz interiors, white plaster.
The way to turn any of this into a real answer is to have someone look at your actual situation. The free estimate is free, itemized and written down, with no deposit and no obligation. Call (844) 511-2320 or start on the Killeen Pool Builders homepage.
Areas Killeen Pool Builders covers
Killeen first, then the surrounding communities of Bell and Coryell counties. Each has its own page with local detail rather than a copy of this one:
- Temple, TX — Bell County, population 82,000
- Copperas Cove, TX — Coryell County, population 36,700
- Harker Heights, TX — Bell County, population 33,100
- Belton, TX — Bell County, population 23,100
- Gatesville, TX — Coryell County, population 16,100
- Nolanville, TX — Bell County, population 5,900
Or jump to the full list of Killeen services.
The Killeen Pool Builders Team
Licensed pool pros in Killeen, TX
Written by the Killeen Pool Builders team — licensed, insured pool pros with 15+ years serving Killeen, TX and the surrounding area.